Hi
I'm trying to configure my new USG110 but have some problems...
This is my scenery:
USG IP is 10.20.1.1
WAN1 port connected to a DSL line in bridge mode
WAN2 port connected to a Cisco VPN router, IP 10.10.1.15
LAN1 segment in 10.20.1.0/24
I just want that if some PC wants to reach 10.10.x.x the traffic go out through WAN2, any other request (web, mail...), to WAN1. Actually all traffic goes to WAN1 so I can't reach any 10.10.x.x address, previously I had a Sonicwall and with NAT this was very easy, just make a rule that all traffic coming from LAN1 to 10.10.1.5 goes to WAN2, but with this USG I can't figure how to do that, I've tried some NAT configurations but no success...
Any hint?
↧