Made a setup where I user the USG 40 to manage VLANs. Experienced the strange behavior that when I disabled LAN2 (was just used to carry the VLANs) it was still functioning fine but in case of power loss the USG stalled - had to reset and configure from the start (I couldn't even load the conf file). Then occasionally I found a conf-file from the time before disabling LAN2 and I was able to restore that configuration, and after enabling LAN2 the USG is not stalling anymore when I disconnect the power cord.
Just wanted to share this observation - in case there are others that experience the same issue.
↧