I'm new to VLANs (and on this forum). And I'm struggeling to get it configurated on a ZyWALL 50 (20 or 100).
What I would like to do:
Create a VLAN, to have a seperate network, and additionally block traffic between VLAN and LAN1&2.
But it confuses me from the first window:
Intreface type: General (?)
Zone: LAN1 (I guess)
Base Port: lan1 (? what does the base port mean?)
VLAN ID: 7 (I will use 192.168.7.x)
Fixed IP: 192.168.7.1
Gateway: blank
DHCP enabled
And here I strand. I connected Port1 (LAN1) to a ZyXEL 1910-24 switch and configured a VLAN on ID 7...
I thought when I connect a device on a port on the VLAN7 on the switch I would get an IP.
That would be too easy.
I searched the internet for examples and support notes. But I'm not getting anywhere. Some say, you need to make a bridge. Others say you need to add routing etc...
I'm sure I'm wrong on different paths, but I would be grateful if anyone can point me in the right direction.
Thanks in advance!
VinzZ
↧
