I'm having some trouble getting my USG60W to do what I need. I looked all over the settings and can't figure it out.
I currently have 2 WANs (cable on P1, DSL on P2), and all my network is on LAN1 over P3.
I'd like to connect some devices over P4, also using LAN1, but assign WAN1/P1 to LAN1/P3 and WAN2/P2 to LAN1/P4.
In other words: devices from P3 and P4 would be on the same LAN, but each group would have separate WAN service.
Is this possible? If so, is it a Tunnel, a Bridge, a Trunk, a Route?
Alternatively, if WANs can't be assigned by LAN ports, can i program specific LAN IPs to use WAN2, and the rest to use WAN1?
I'd appreciate any assitance with this.
↧