Got a working VPN setup for my ZyWALL 2WG. We are now on ZyWALL 20W and the ZyWALL IPSec VPN Client can connect to the 20W and I can ping the 20W via the established VPN connection (ping the LAN IP). But I cannot access any other IP-adress on the LAN.
I have read scenario 5 and 11 in this paper ftp://ftp.zyxel.com/ZYWALL_USG_20W/support_note/ZYWALL%20USG%2020W_2.pdf and my setup is pretty much like scenario 5. To give WLAN users access to LAN ressources I defined a bridge. Therefore I have set the local policy of the VPN connection to Bridge.
I am not sure which information will be valuable to provide. I think the problem must be either of:
- firewall
- routing
- ipsec configuration
The strange thing is that the same setup worked on the 2WG.
The firewall allows LAN1 to any and IPSEC_VPN til LAN1
Member of the IPSEC_VPN is the vpn connection called IPSEC_DIALIN_VPN
The only Policy Route I have is any to Bridge
So for at start - which information will be useful?
btw: The VPN client recieves the ip-adress 10.10.10.10. The Bridge subnet is 10.6.6.0. Wasn't a problem on the 2WG.
↧