Hello everyone,
I have an Zywall USG100 that i would like to use for sending IPTV traffic to my digibox on the network. My ISP is "Telenet" (Belgium) and they are not using any VLAN on the IPTV network.
My WAN interface receives the public IP adres from the modem and i should need to get the public IP to my digibox so i could get interactive TV (they do MAC adres control).
The internal LAN (interface1) has a DHCP server on the 192.168.1.X network and i made a VLAN2 for a Guest Wifi network in the 192.168.20.X range also on interface1.
There are 2 switches in the network that handle all the traffic (also for VLAN), a HP Procurve 1800-24G and a HP Procurve 1810G-8.
At this moment i made a VLAN3 that i want to use for the IPTV traffic, but i don't know how to configure the Zywall so that the public IP come's on the VLAN3. After the VLAN3 receives the public IP i need to configure my switches so that the port where my digibox will be connected is also on VLAN3. But VLAN3 will leave the Zywall trough interface1, just like the rest of my data.
Could someone give me some help on how i get the configuration right? I googled this but i can't find any good workarounds.
Here is a link to my dropbox folder where you can find the setup and some screenshot of the zywall config. If there are any question just ask, my knowledge isn't enough to configure this.
https://www.dropbox.com/sh/obk5763p6wwz6a0/AACEP-bKeAolT-KgI-WUTvvMa
Thanks in advance
↧