Ugh!! I just purchased a Zywall USG-100 and am pulling my hair out after spending all Sunday trying to work out what the heck i'm doing wrong.
I have a little bit of networking experience having configured ISA2004 but this USG-100 is so UI challenged and the user guide doesn't seem to answer my specific issue (or i'm obviously missing it as this is pretty basic requirement).
Basically the reason for the usg-100 purchase is I'm upgrading to SBS2008 for my home office (currently using SBS2003).
Because SBS2008 is no longer is a 2nic solution and no longer has ISA built in I purchased a USG-100 (overkill for my home office requirements but figure faster=better).
I have spent the whole day trying to work this out and am at throwing it out the window stage.
Basically my plan was install the USG-100 between the cable modem and the SBS2003 box this sunday, get used to the config and then change up the network next sunday so it would run cable modem-usg100-24 port switch to the various servers and workstations (1 x sbs2008, 2 laptops, 2 desktops, 1 media server, 1 asterisk pbx and a second windows server 2008 that I run about 20 websites on).
basically the outbound traffic is fine, I worked out how to get an 72.x.x.x ip address for the usg-100 from my cable modem and the dhcp scope for desktops is still using the sbs2003 server 192.1.1.0/24
However my issue is WHERE on the usg-100 do I configure the www addresses it is supposed to allow on the sbs2003 and server 2008???
Basically any FQDN url I type from the wan (and and or lan) is going to the zywall log in page?
Even if I setup a firewall rule allow any from wan to access Lan1......it still doesn't work.
What am I missing?
↧