How I can add and remove VLAN tags on PPPoE
My Provider want to have all PPPoE packets with a VLAN-7 tag. That's why the USG 20 should add VLAN-7 tags on outgoing and remove the tags from incoming packets. Is it possible? I am confused that I...
View ArticleZyXEL Noob
Greetings, I just purchased a ZyXEL USG 20 and I am totally lost on how to set this up. I am trying to replace a Cisco RV4000, but this is so different that I am not sure where to begin with what I...
View ArticleNetwork issue, not sure where to look.
Hi Folks, I just got a new switch (unmanaged) and set up 4 Macs with aggregated links. One Mac set up, perfect. Second Mac set up, both Macs lose network connectivity. Meanwhile other computers on the...
View ArticleCan I setup a USG 50 to route ALL WAN traffic though a commercial VPN?
I'd like to setup VPN over my whole LAN . Would I have to enter VPN settings on each machine, or can it be done at router level? I contacted tech support at a couple of VPN companies, and they only...
View ArticleUSG20 disconnecting IPsec tunnel
Hello, i have a server with Kerio Control running on it. this server is the main server shere two sites are connecting. On first site i have USG300 (working fine and never disconnects) and on second...
View ArticleUSG100: access to multiple offices over L2TP
Hey, colleagues, first of all I want to say Thank you for all of you. I permanently read this forum and find solutions for my problems. It seems that this time I was unable to do so, so I need your...
View ArticleLAN clients isolation.
How can I isolate DHCP clients on the same subnet from each other? Kind of how it's usually done for WiFi. But I need this for nodes connected to a specific virtual interface under LAN1. TIA
View ArticleWhat do I need to do to allow VPN traffic to pass through?
I have a Mac mini running a VPN service and file sharing service. A ZyWall USG 20 handles DHCP on the network. The VPN is set up, user accounts ready to go but noone can connect. As I'm still pretty...
View ArticleZyWALL USG 200 3.30(AQU.3) Released
v3.30(AQU.3) firmware: ftp://ftp.zyxel.com/ZYWALL_USG_200/firmware/ZYWALL%20USG%20200_3.30(AQU.3)C0.zip
View ArticleUSG 20W - SSL VPN Support
Does the USG 20W support SSL VPN clients? From what I can tell yes, but only 1 concurrent user? Can additional licenses be purchased? I see some of the higher models there are license options to...
View ArticleFirmware 3.30 updates for USG series available
Available at this link: ftp://ftp.zyxel.com/ZyWALL_USG_2000/firmware/ZyWALL%20USG%202000_3.30(AQW.3)C0.zip ftp://ftp.zyxel.com/ZyWALL_USG_1000/firmware/ZyWALL%20USG%201000_3.30(AQV.3)C0.zip...
View ArticleNeed help turning a ZyXel q1000z into a WAP!
I've been trying everything... apparently not many people have done this, I'm starting to doubt it can even be done even though I've found nothing saying it can't. I just made the switch from...
View ArticleIs my AV ON or OFF?
For several months, probably more than 12, AV is shown "expired" in the Dashboard and AV is not enabled in Configuration/Anti-X/Anti-Virus/General, but recent configuration files show, in part:...
View Articleplink shutdown command to USG50
I have been unable to shutdown my USG50 using plink. the following logs in but fails to execute shutdown: plink -ssh -v -2 -pw adminpassword admin@xxx.xxx.xxx.xxx shutdown adminpassword is the router...
View ArticleQoS USG 100 Firmware 3.30(AQQ.3)C0
I made some mistakes in my testing [ http://www.dslreports.com/forum/r28949058-ZyWALL-USG-200-3.30-AQU.3-Released ] When I reset to factory default and then reloaded my saved config I did not check to...
View ArticleUSG50 with 2 WAN; VoIP; keep slower as failover?
I'm using the Zywall USG50 for traffic management and dual WAN capability. I have a cable internet line at 30/4 and a dsl line at 6/768k. In this environment, I use VoIP for almost all calls. I...
View ArticlePreventing DoS attacks with Zyxel routers and/or switches?
My network has been hit with Syn attacks over the weekend and I'm looking for advice on how to prevent them in the future. We have a 40 MB fiber connection that we share with our neighbors. We also...
View ArticleVPN L2TP/IPsec on USG 100 with Double WAN/LAN and new Firmware 3.30(AQQ.3)C0
Hi to all, thanks in advance for your support. I'm new of this forum and about the topic i have followed the quick guide that i found about the USG 100. I'm about to become crazy because i still don't...
View ArticleFios router with existing Zyxel router
Hello, I will be getting Fios this week (had it 5+ years ago). Anyways, I will be getting a built in router as a package. How would I implement my existing Zyxel usg20 router into the mix? I am...
View ArticleVPN Tunnel help needed
Hello experts I'm in the process of configuring a VPN Tunnel but somehow I don't manage to get it up and running. Here are some details about the setup: Local Setup (on site A) - Zyxell Zywall USG...
View Article